Metalmart Roofing Materials and Metal Products for DIY

Metal Roof Hemming a Panel Video

Marty — Fri, 27 Aug 2010 17:31:37 +0000

Marty — Fri, 27 Aug 2010 17:23:15 +0000

Marty — Fri, 27 Aug 2010 14:49:15 +0000

Marty — Thu, 19 Aug 2010 14:53:02 +0000

SELECT and TRIM… Choose appropriate Master Flash with opening at least 20% smaller than pipe diameter. If necessary trim opening to 20% smaller than pipe diameter.
SLIDE… Slide Master Flash down over pipe. (A non-petroleum base lubricant will ease installation.)
FORM… Press Master Flash down,bending it to conform to roof profile or roof irregularities. A blunt tool will help press flashing into tight roof angles.
SEAL… Apply silicone sealant between base and roof.
FASTEN… Use fastener to complete sealing. For UPC installation, fastener spacing may not exceed 1-1/2″ (38mm).

Marty — Thu, 19 Aug 2010 14:31:18 +0000

SELECT and TRIM… Chose appropriate Retro Fit. If necessary trim opening to pipe Diameter
WRAP… Wrap Retro-Fit around pipe and install all snap rivets to seal flange.
FORM… Press Master Flash down, bending it to conform to roof profile or roof irregularities. A blunt tool will help press flashing into tight roof angles.
SEAL… Apply silicone sealant between base, roof, and to the top of flashing
FASTEN… Use fasteners to complete sealing. For UPC installation. Fastener spacing may not exceed 1 1/2″ (38mm)
INSTALL CABLE TIE… Install supplied cable tie at uppermost part of Retro-Fit and apply sealant to any gaps.

Marty — Wed, 18 Aug 2010 20:58:45 +0000

Marty — Wed, 18 Aug 2010 14:53:16 +0000

Marty — Wed, 18 Aug 2010 14:25:14 +0000

Marty — Fri, 13 Aug 2010 16:05:09 +0000

800-947-0249 (T)
801-768-3332 (P)
801-768-3349 (F)

Marty — Fri, 13 Aug 2010 16:04:05 +0000

800-947-0249 (T)
801-768-3332 (P)
801-768-3349 (F)